| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE DRAIN HOSES ON THE BACK OF THE MACHINE
|
| 2 |
|
PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 3 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 4 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE.
| Wrench-Allen metric 6.0mm |
|
|
| 5 |
|
LIFT THE TANK TO OPEN THE MACHINE
|
| 6 |
|
REMOVE THE BATTERIES
|
| 7 |
|
REMOVE THE 2 BOLTS FROM THE BRUSH HEAD SHROUD
| Screwdriver-phillips |
|
|
| 8 |
|
REMOVE THE 2 BOLTS FROM THE BRUSH BELT COVER
| Wrench-Allen metric 5.0mm |
|
|
| 9 |
|
PULL TO REMOVE THE BELT COVER FROM THE MACHINE
|
| 10 |
|
LAY THE MACHINE ON ITS SIDE
|
| 11 |
|
PUSH ON THE BRUSH BELT TO CHECK THE TENSION. BELT SHOULD BE TAUT. THERE SHOULD NOT BE MUCH GIVE IN THE BELT.
|
| 12 |
|
REVERSE STEPS 4 THRU 10 TO REASSEMBLE THE MACHINE. FILL SOLUTION TANK IF NEEDED
|